How do I get my charger into pairing mode?

To get your EV charger into pairing mode, simply follow these steps:

1. Turn Off and On: Start by turning off the charger from the power supply. After a brief moment, turn the charger back on. This action will initiate pairing mode, which lasts for approximately 60 seconds.
2. Connectivity Setup:
3. On your phone's Wi-Fi settings, search for available networks.
4. Look for the charger's serial number among the displayed networks. 
   Note: Never connect to the serial number network; this is just for identification.
5. If you can't see the charger's serial number, try the following steps:
6. Switch off the Wi-Fi router.
7. Turn off the charger from the power supply.
8. After a short interval, turn the charger back on.

Note: If the Wi-Fi router is left on, the charger may quickly connect to it, which may prevent the emission of a hotspot signal for pairing.